Retain a Gauze can ready.
Clearances are so tight on every Harley that removing the fuel vat normally makes engine repair jobs yet easier. Thanks to a important group of the wiring harness runs under the fuel cistern on Course of action Glides, Harley-Davidson and many aftermarket manufacturers oftentimes reccomend removing the fuel vehicle to business on many electrical connections to the console or within the fairing. Removing the fuel tank on some Harleys is basically a withdraw and unbolt career. Thanks to Method Glides are so convoluted, on the contrary, removing the vat from one of them requires further steps.
Instructions
1. Unclip the side comprehend, in front of your saddlebag, that contains your fuse block. The fuse block is under the exactly side embrace on Pathway Glides built in some second childhood and under the left for others. Consult your work book to be definite.
2. Shift into impartial and countdown the motorcycle in a well-ventilated dwelling. With the motorcycle running, pull the fuel pump fuse with a fuse puller. Authorize the engine to sputter to a bar.
3. Eccentric person the engine for another five seconds. This Testament purge the pressurized Gauze from the Method Glide's fuel lines.
11. Disconnect the fuel line where it connects to the tank by pulling on it. Drain the remaining gasoline into the gas can.12.
Loosen the denying battery cable. Remove the cable from the con terminal with a box wrench.
6. Siphon the petrol from newer style Road Glides with a mechanical siphoning Slogan into what Harley calls an "adequately sized" Gauze can. Harley Davidson changed the design of their fuel filler port to prevent easy siphoning in the middle of the Two thousand seven model year.
7. Connect one end of a three-foot length of rubber or plastic hose to the spout of a small funnel to drain gas from older Road Glides. Place the opposite end of the hose in a gas can.
8. Pull and disconnect one end of the crossover hose on older Road Glides. Allow gasoline from the crossover connection to drain into the funnel.
9. Remove the acorn nut from the console with a box wrench. Lift, but do not remove, the console.
10. Pull and disconnect the fuel level sender and fuel pump plug in electrical connections under the console.
4. Remove the seat reminiscence bolt and washer on the rear of the seat with an Allen wrench. Remove the seat to access the battery.5.
Remove the rear fuel tank mounting bolt, nut and washers with a box wrench. Remove the front mounting bolt, nut and washers.
13. Lift, but do not remove, the tank. Disconnect the pigtail wiring harness connection under the tank.
14. Carefully remove the tank
