The position of your Buick's function window is controlled by a switch on the door that sends electrical signals to the regulator Engine. Engine motions are transfered to the window buttoned up the regulator arm. A metal becoming on the backside of the window, called a sash channel, connects to the regulator arm curler.3. Remove all of the trim panel retaining screws with a screwdriver. Pry the panel retainer clips loose with the putty knife. Insert the knife between the clip and the door, but do not pry on the trim panel itself.
1. Roll the window all the means up on your Buick Regal. Open the door and place a rag over the weatherstripping at the top of the door near the middle of the window. Place a piece of tape over the rag and press it firmly to the window on both sides.
2. Pry the window control switch, courtesy light and the electric mirror control out of the panel with a putty knife. Unplug them then set them aside.
The curler is held slave in the channel, and the connexion provides close and smooth method of the window. Chronology and wear of the window Engine Testament consideration it to collapse and miss replacement.
Instructions
Remove the panel from the door and disconnect the wiring harness. Peel back the watershield, as necessary, to access the motor.4. Open the hood then disconnect the battery's negative cable with a wrench.
5. Remove the rivets or bolts that hold the motor in the door frame. Move the motor, as necessary, to unhook the regulator arm from the sash channel. Remove the motor from the door.
