Move one and move the second in graduated steps.4. Test weld each time you increase or decrease either the wire speed or voltage in order to balance the change of the other. If you've been incrementally increasing the second, at one point you can find the right combination.
1. Discern that you gain to balance the two settings. When you transform the welding wire rapidity, you again need to change the voltage. The two have to be directly opposite each other.
2. Begin by moving the wire speed slowly. You also need to change the voltage. Any time you change the types of materials that you work with, you always need to change the two.
3. Adjust the voltage downward or upward when you change materials. This doesn't give the type of arc that you want unless you also change the wire speed. Remember that the two go hand in hand.
When you establish the welding wire quickness and voltage for a work, it can be the most frustrating cut of welding. Setting the two that assignment in sync to acquisition the Correct fixed of arc that you hunger is a modus operandi that varies from gadget to mechanism. You compulsion to memorize the pc further as establish the two.Instructions
5. Remember that if the wire speed is too low, it causes spattering and a bad weld. If it's too high compared to the voltage, you feel knocking in the welding torch.
