A Chrysler Town & Community is a luxury automobile, on the other hand its brake sort is priceless. Replacing arts enjoy the brake calipers is bad left in the hands of an Professional. Consult with your mechanic before attempting to interchange a caliper on a Chrysler or any other vehicle.
Attach the brake hose to the caliper with new washers. Tighten the banjo bolt to Thirty five foot pounds.9. Bleed the brake system.
This is recommended before any type of preservation.
2. Hoist and safely abutment the vehicle on the side you'll duty on. Remove the revolve in front of the brake meeting you're targeting.
3. Disconnect the brake hose from the caliper by removing the attaching banjo bolt. Discard the seal washers. Plug the brake hose with a quota of rubber to prevent fluid leakage and contamination.
4. Remove the american man pin bolts securing the caliper to the steering knuckle. Slowly slide the caliper outside from the knuckle. Slide the caliper's contrary foot outside from under the machined abutment on the knuckle.
Installing the New
5. Lubricate the abutment surfaces on the steering knuckle. Use silicone grease or any multipurpose lubricant.
6. Position the new caliper over the brake pads and disc rotor. Be sure not to damage the caliper seals or guide pin bushings with the steering knuckle bosses.
7. Install the caliper guide pin bolts, making sure you don't cross thread them. Torque the front caliper bolts to One hundred ninety five inch pounds and the rear caliper bolts to One hundred ninety two inch pounds.
8.
Instructions
Removing the Old
1. Section off the automobile's faculty function by disconnecting the cable from the antagonistic battery terminal.Open the bleeder valve, attach a transparent hose to it and have another person hold down on the pedal to remove air from the system.
10. Reconnect the wheel and tire. Torque the lug nuts to One hundred foot pounds. Torque all the nuts in a star pattern sequence to half specifications, and then repeat to the full 100.
11. Pump the brake pedal multiple times to make sure the brake pedal is firm. Then test the vehicle and brakes on the road.
