Place the connector shell over the plastic collar cover plate and push it onto the cable until it covers the collar. Push the base up against the connector shell. Screw the base into the connector shell.
Instructions
1. Unscrew the pattern off the coax connector. Remove the collar and the plastic collar subsume plate from inside the connector's shell, Abode these parts on a table.
2. Incision off the coax connector from the aim of the antenna's cable with wire cutters. Put the example on the cable and push it back 3-4 inches toward the other location of the cable. Repeat this with the collar, lone push it Three inches in complete.
3. Catch the sides of the collar with the entrance of the needle-nosed pliers. Squeeze the needle-nosed pliers to secure the collar to the cable.
4. Practise a 2-inch slit from the incision location with the blade of a advantage bolo. Peel back the outer insulation from the cable with your fingers. Abbreviate the outer insulation off from the cable with the scissors.
5. Pull the copper wire surrounding the plastic sheath at the centre of the cable back. Twist the copper wire between your fingers to design a ridge sorrounding the plastic sheath.
6. Shorten an inch in from the point of the plastic sheath with the blade of the utility knife. Peel back the plastic sheath from the copper wire. Cut the plastic sheath off the cable with the scissors.
7. Thread the plastic collar cover plate through the copper wire and up against the collar.
An indoor TV antenna attaches to a television locate down a coaxial cable attached to the antenna's word output and the TV's locution input. A broken coax connector extreme of a coaxial cable that is permanently attached to an antenna must be replaced or it cannot be used. To set the antenna's coax connector, a replacement coax connector from a hardware store and a hardly any tools commonly initiate enclosing the crib are needed. The procedure is straightforward and does not wish any specialized electrical skills.
