The door panels on a Two thousand three GM Sierra 2500HD dominion speakers, lights, window regulators and other components. The individual plan to replace or remove these parts is to inaugural remove the door panel. The panel can be removed in approximately Thirty minutes using a meagre tools.
Instructions
1. Remove triangle-shaped panel antipodal the elsewhere mirror located at the front/top of the door panel. Commence by pulling the top of the triangle outside, followed by pulling the sides. The panel should pop gone easily.
2. Stare at the door console switch module, which holds all of the switches for the door such as the door locks and window controls. There are two slots along the Joint of the module. Accommodation a inconsequential, sharp pointed phenomenon, comparable a pick, into these slots to pry up and remove the module. Unplug the connectors from the underside of the module to remove it completely. Remove the Seven mm bolt in the door that was formerly close by the module.
3. Pop this out by using a flat-head screwdriver.5. Use a flat-head screwdriver to pry the door lock surround up and away from the door.
4. Unscrew the screw in the rear of the door panel that is hidden when the door is shut. Open the door to find it along the rear of the panel, facing out. There is a plastic clip along the front side of the door panel. Set the plastic surround environing the door handle. Pull up on the rear side of it and then pop it out. There are several clips holding the surround in place. Pull it out and then slide it forward to remove it completely.
Pull it off and remove the screw located behind the surround. Remove the last screw in the door panel, which is located under the solid door handle against the door panel.
6. Pull up on the door panel to loosen it from the door. Reach behind the panel to disconnect the wire connections between the speakers and lights. The door panel is now completely removed.
