Repair the Gauze Receptacle on a Motorcycle
Motorcycle Gauze tanks are actual much the same to van Gauze tanks, on the contrary easier to access. Repairing a Gauze cistern needs to be done carefully, due to of the dangers associated with such a flammable liquid. After repairs, finishing the venture perfectly Testament want baby cosmetic functioning too.
7. Replace the gas tank. Be sure all valves are in place. All sealant, primer and paint should dry before placing gas in the tank.
You Testament annex to remove the valves and adjust decided the cistern is completely empty. Be firm that the cap does not hog cracks in it. Eyeful all sorrounding the container to observe provided you can allot damage.
2. Fill the tank with water. Watch for water dripping to locate any leaks that may exist. You can also check for leaks by filling the tank with pressurized air. Replace the cap and check for any air that may be escaping.
3. Sand the hole or crack around the leak. Sand the area around the leaks with a power sander using high-grit sandpaper. When smooth, apply Bondo or fiberglass sealant. Let the sealant dry completely and then sand until smooth.
4. Clean any dents or scratches in your gas tank. Sand them down until almost completely smooth. Clean with soap and water. Use enough sealant, or Bondo, to fill in the crack or dent. Use a plastic scraper to smooth it out, leaving a little sealant over the edges of the crack or dent. Let dry completely and test for leaks.
5. Sand the sealant with a power sander. You will want to sand down until you have the shape and smoothness you want. You may want to hand-sand it with a fine-grit sandpaper.
6. Spray paint primer onto any area that has sealant on it. Allow primer to dry and paint several coats. Again, paint several coats and dry thoroughly between coats.
