From era to age, the cable that runs from the parking brake lever inside the vehicle to the actual brake Testament weaken, split or simply stretch. When this happens, you must convert the cable for defended course of the vehicle. To remove the cable there are a figure of safety measures to perform before undertaking this duty.
Instructions
1. Chock the front tires to prevent the vehicle from rolling forward off the jacks that are under the rear axle. Area jack stands under the rear axle to stabilize the vehivle as you duty under it on the brake development.3. Loosen the lug nuts on the turn and booty the circle off the vehicle.
Without stoppers in front and at the end the front tires you risk the vehicle rolling forward or backward and falling off the jack stands. Provided you are under the vehicle when that happens, you Testament be seriously bruised whether not killed.2. Jack the rear axle of the machine up To admit the back wheels to rotate freely.
Once you hold removed the trundle you demand to remove the drum from the turn. The drum may stick a bit so bland tapping may be required to loosen it from the rotate. Once the drum is off the spin, you Testament be able to scrutinize the brake shoes. The brake mechanism and the head of the emergency cable attachment purpose can be located. Remove the debilitated cable by disassembling the mechanism. Apply caution to dismantle individual to the purpose where the cable comes free of charge.
4. Remove the experienced cable by feeding it buttoned up the opening and thread the contemporary cable back finished the opening. Reattach the brake mechanism. Now it is possible to remount the drum and attach the rim and wheel.
5. Use the socket wrench to loosen the two bolts that hold the end of the cable to the inside of the wheel. For seized bolts, apply a small amount of penetrating oil. Allow the oil to work for about Fifteen minutes and then try again. Disconnect the cable from the backside of the wheel.
6. Follow the cable forward and locate where it enters the inside of the car. Move inside the car and find the cable. Continue to follow the cable until you locate the attachment point either on the console or next to the brake in the floorboard of the driver side seat.
7. Loosen the nut that applies tension to the cable until the cable is free from the parking brake handle and mechanism on the inside of the vehicle.
