The manufacturer recommends that the timing zone in One thousand nine hundred ninety nine washed-up Two thousand 3.3 Mercury Villager engines be replaced at 105,000-mile intervals. This figure was arrived at after studying the assistance chronicle on this engine. It is classified as a freewheeling engine where, in the business of a timing belt failure, it is unlikely that any engine damage would chance. Remove the upper radiator hose and the air conditioning loafer pulley and bracket. Remove the coolant bypass hose. Remove the wiring harness from the upper timing belt cover and locate it aside.
Up thrust and assist the vehicle on jack stands. Remove the air conditioning ride zone and bleed the radiator. Remove the true spin and the splashguard. Remove the frill handle belts.
2. Using the crankshaft pulley remover thing #303-009-303-410, remove the crankshaft bolt and the pulley. Remove the doctor pump pulley and the timing cestuses lower include bolts. The epoch to alter the timing girdle for an experienced technician is Four hours and Ten minutes.
Instructions
1. Remove both timing cestuses covers and the band handle washer on the crankshaft sprocket.3. Temporarily install the crankshaft pulley bolt and turn the engine clockwise until the marks on the crankshaft sprocket at the Five o'Watch position lines up with the objective on the block. Trial the camshaft sprockets and dash off confident the lines on the sprockets borderline up with their comparable marks on the rear timing sash involve.
4. Loosen the tensioner aficionado and remove the timing girth. Build sure all the timing marks are lined up and proceed to install the new timing belt in a counterclockwise direction, starting with the right side of the crankshaft sprocket to the camshaft sprocket, keeping all the tension on this side away from the tensioner.
5. Insert an Allen wrench in the tensioner and turn the tensioner one turn clockwise and then three turns counterclockwise. Allow the tensioner to stabilize for a moment and then torque the tensioner bolt to Sixty one foot pounds of torque.
6. Turn the engine two rotations clockwise and recheck the timing marks. Install all components in reverse order of removal and torque the crankshaft bolt to One hundred forty six foot pounds of torque. Fill the cooling system.
