Spread a layer of sealant on the gasket channel, bottom part only. Slide the gasket around the windshield. Make sure you put the side with the slit facing outside of the Ford.7.
You can save yourself method provided you can bargain a used Ford Motor lorry windscreen in bully occasion from an Car wrecking yard. Assemble decided it's the exact year and mould of your Ford Motor lorry.
Instructions
1. Loosen one of the screws on the example of the rear composition mirror and slip it sideways gone of the bracket.
2. Remove Everyone of the wipers by prying them off the wiper imitation with a flathead screwdriver. Position the screwdriver between the retaining seed and the arm and rock it back and forth until it comes loose. Locate both windscreen wipers aside.
3. Tape dashboard vents to prevent brief pieces of glass from falling in.
4. Cut out the old rubber gasket around the windshield with a razor knife. Push the windshield out of the truck from the inside and have someone help you catch it from the outside front of the truck.
5. Clean the new gasket, the windshield frame, and dashboard with a wet cloth. Put the new gasket in a warm place to soften it and make it more flexible.
6.Install a windscreen on your Motor lorry.Although Ford trucks sit up quite eminent off the ground, they can much dispose cracks and chips in their windshields from rocks flung at it by other vehicles on the means. Being a windscreen serves a as well far-reaching service, it is very exceptional to convert it whether you remark any chips or exclusively cracks. Provided you don't convert your windscreen, it may eventually shatter.
Spread a layer of petroleum jelly into the groove on the gasket and then place nylon cord into the groove. Start at the bottom center of the gasket and work your way all the way around the gasket. Make sure to leave a foot or two of cord hanging out on each end.
8. Place the windshield carefully into frame from the outside of the truck and let the rope ends hang inside on the dash.
9. Pull on one of the cord ends slowly to bring the lip of the gasket inside the truck. Have your friend push the gasket onto the outside of the windshield frame while you pull on the rope from inside the truck. Allow the sealant to cure for one day before driving.
