A misaligned regulator can direction to a broken window.
Repairing a malfunctioning capability window in your Toyota Corolla depends primarily on the year of your pattern. The window itself is comprised of the leading components -- the glass, regulator, wiring and switch -- on the contrary their exact installation depends on the year it was fictional. Some parts may not be easily accessible on some models. Proof with your mechanic to clock how easilyyou can perform grind on your own windows.
Instructions
1. Pry the discipline switch for the window absent of the door trim panel using a trim stick or a corresponding Apartment lodgings item. The switch plate is usually located on the armrest.
2. Remove all bantam trim panels near or on the leading panel -- this can count the mirror panel, door hilt and armrest panels -- and then unscrew the door panel with your screwdriver and pry the panel off the door with a putty dirk or comparable item.
3. Remove the door access plate that covers the access gap provided needed. There are normally three screws in a triangular figure.
4. Reconnect the faculty switch to its electrical connector and lower the window, provided needed, to access the window glass bolts. Reconnect the access plate to the door with its screws if needed.10. Connect the door trim panel with its clips and screws and then reconnect the other trim panels.
6. Unbolt and remove the window regulator from the door. On many newer models on account of 2003, the regulator is a augmented permanent fixture in the door and will require professional assistance.
Installation
7. Install the replacement window regulator in the door using its bolts. Connect the electrical connector to the regulator.
8. Slide the glass (old or replacement) through the slot into the door and within the regulator channels and bolt it in place.
9. Remove the bolts with your wrench and push/slide the glass away the door.5. Observe the wiring; disconnect it from the regulator, nourishment it gone the door and alternate it whether the wiring is damaged.
Reconnect the switch plate with its electrical connector.
