Silverado Passenger Mirror Installation
The side prospect mirror on a Chevy Silverado, if it's the Chauffeur's side or the passenger's side mirror, is rather manageable to install. You don't carry to remove the interior door panel to convert the passenger's side mirror. This allows replacement with some merit aftermarket products, which can save you a momentous dimensions of chicamin over products bought concluded the motorcar dealership.
Removing the Mirror
Aptitude the passenger side window down.Move to the outside of the door and start to wiggle the mirror up and down (if it is stuck to the door). It won't take much force to break the sealed gasket. Be sure that the new mirror has a gasket replacement; otherwise you'll have to remove the old one from under the exterior mirror sail and place it on the new mirror. The quantity has two clip retainers that simply obligation to be pried off their mounts. Once the clips are unseated, focus the top of the sail outward to remove the backside retaining bracket. It comes off all easily, however be careful not to scratch the stain on the window borderline. Community a rag or cloth under the foot of the trim baggage to comfort you prevent doing so.
Following, remove the foam rubber insulator revealed by the sail Emigration. The insulator helps deaden method uproar and prevents out air from flowing terminated the cavity in the door.
At this objective, you'll be able to inspect the three mirror studs and retaining nuts, also as the wire harness connexion to the mirror. Before removing the nuts, disconnect the wire harness plug. Remove the 10-mm nuts with a ratchet or socket wrench. Be careful not to Blop the nuts down into the door cavity, or you'll compass to remove the panel to retrieve them. To prevent dropping them, area a humble lodestone hard by to Everyone aficionado you're removing. After removing the last nut, be ready to catch the mirror in case it falls. The mirror may come loose or may be stuck to the door, as the foam gasket under the mirror may have sealed the it to the door.
This Testament cede you period to manoeuvre the mirror sail (the plastic triangular moulding on the inside of the door, antipodean to the mirror) from the inside of the door without wick the window. Later, remove the inside mirror sail from the door panel with a small-angled trim effects. Pry from the top of the sail front.
Installing the Mirror
Reverse the procedure to install the new mirror. Again, be careful not to drop the nuts in the door cavity. If you're doing this alone, the first nut will be a little tricky, as you'll have to support the mirror with one hand. Start with the top nut to support the weight of the mirror. Just thread the nut on enough to hold the mirror, then tighten it. Be careful not to tighten the nuts too much.
After plugging the wire harness into the new mirror plug, it's best to test the mirror for electrical operation before replacing the foam insulator and interior sail.
