accepted clutch
A clutch and vigour plate bullwork well-organized to transfer turning faculty between your engine and the transaxle. Over day your clutch and energy plate Testament wear elsewhere and it Testament originate to drag or slip, which Testament accomplish shifting gears unreliable and rigid to effect. When this starts to happen you be versed it Testament be extent to alter both the clutch and the compel plate.
Instructions
1. Remove the con (ebon) battery cable.
2. Hoist the motorcar using the floor jack and device it with jack stands. Remove the floor jack when you corner the vehivle safely supported with the jack stands.
3. Community the floor jack under the transaxle, nevertheless don't hoist the transaxle, stand the jack Sufficiently so that the transaxle is supported. Remove the bolts that mastery the transaxle to the engine. You Testament extremity to appropriateness both wrenches and a ratchet and sockets.
4. Movement the transaxle fair-minded Sufficiently so that you can include evident access to the clutch.
5. Advantage your scratching Brad-awl on the pressure plate to objective the clutch alignments. Although changing the pressure plate when you're changing the clutch will save you a lot of time and effort in the long run.
6. Turn the pressure plate bolts two turns counterclockwise going in a crisscross pattern until you can remove the bolts by hand. Removing the bolts this way keeps the pressure plate from warping. When you go to remove the clutch from the car make sure you have a good grip on it because it does have some weight to it, which makes it awkward to move.
7. Clean off the surface of the flywheel with brake cleaner. Then put on the clutch and pressure plate, make sure that the friction side of the clutch is facing the pressure plate. Line up the pressure plates dowel holes with the dowels on the flywheel. Reinsert the clutch bolts and screw them in finger-tight.
8. Install and tighten the transaxle bolts to the engine.11. Put the vehicle on the ground and reconnect the battery cable.
Move the transaxle so that it is aligned with the clutch disc splines. Align the transaxle case to the engine block and push it into place against the cylinder block.
10. Put the clutch disc alignment tool into the center hole of the clutch. Tighten the clutch bolts two turns at a time, working in a crisscross pattern. Tighten the bolts to Nineteen foot pounds of torque.9.
12. Take the car for a short test drive to make sure that the clutch is working properly.
