How Conclude I Remove Spot Welds on a 1965 Mustang Fender Apron?
Spot welds are commonly used to associate two Apartment lodgings panels of a automobile thing well-adjusted. On the early Mustangs, One thousand nine hundred sixty four finished 1968, the front and rear aprons were attached to the shock Garret and the frame condemn with spot welds. To convert one of the aprons, all spot welds must be removed to install a dissimilar panel. The most regular inner fender apron that needs replacing is the front passenger apron. The battery is located along that apron and tends To shatter it over the senility.
Instructions
1. Grounds the van on a indurated, equable surface. Fix the emergency brake and chock the wheels.
2. Remove all of the components from the apron panel with the appropriately-sized sockets and wrenches. For the front passenger apron panel, disconnect the battery leads and the battery retainer then remove the battery. Remove the two bolts holding the starter solenoid in compass and deed the solenoid away of the fashion. Remove the bolts for the battery tray and remove it. Remove the fender bolts, then disconnect the headlight harness and remove the fender.
3. Fix the spot welds in the fender apron that committal to be drilled gone. There are welds vertically along the shock Garret and radiator help, and horizontally along the front frame castigate. The secret to doing a good job is to drill only through the top panel while leaving the under panel intact. Using a regular drill will typically put a hole through the second panel before completely cutting the spot weld. Drill through the top section of all the spot welds on the apron.5.
There are besides various on Everyone location of the apron along the fender attachment edge.4. Manipulate a good spot weld cutter. Do not be tempted to use a 3/8- or 1/2-inch regular drill bit.
Separate the two panels with a sharp chisel. Work carefully to avoid damaging the second panel. Once the panel is removed, the replacement panel can be installed.
