This eliminates having to flap with carefulness the door conduct while dealing with the glass and other parts of the door.
Instructions
1. Remove the window Eccentric person using a horseshoe-clip removing belongings.Replacing the door glass on a Camaro is de rigueur whether the glass is chipped or broken. You can expect this project to yield the more advantageous chunk of a time. When you interchange the door glass, it is a worthy belief to prop the door open using a breeze block or considerable brick.
District the baggage between the Eccentric person and the door. Toggle it until the clip comes outside. Slide the Eccentric person off its shaft.
2. Unscrew the armrest and the door lock handle. On some models, there may be other screws inside the door pulls. Disengage the circlip from the door bolt pull rod. Remove these items.
3. Catch off the bantam metal clips from the edges of the trim panel using a Hairpin puller. Utilize this factor to remove the "Christmas tree" plastic clips without defective the hardboard backing on the trim panel. Lift the door trim panel straight up. It should come elsewhere easily. Probation the contingency of the inboard door felt and the tar-paper irrigate seal, and exchange them provided needed.
4. Remove the outer window felt using an counteract screwdriver. Takings outside the plastic rivets, whether any, using needle-nose pliers.
5. Unbolt the two stabilizers atop the door. You very obtain to remove the lower and upper stops to receive the glass out. To remove the front upper stop and rear upper stop, crank the window to three-quarters of the way down. To remove the stop bolts that are in slotted channels, remove the front and rear lower sash channel nuts.
6. Back out the adjustment of the front and rear upper guide bolts that control the in-out tilt adjustment, and carefully lift the old glass out.
7. Put in the new glass. Swap the hardware that is in the old glass to the new one using common hex bolts. To transfer the forward bell crank assembly that is retained in the old glass with special two-hole nuts to the new glass, a homemade two-pronged tool or Snap-on S9610 is needed.
8. Loosen the star-shaped plastic guide that helped the old glass from rubbing in the track and snap it on to the new glass. This can be done using only your hands. Wiggle it back and forth and lower the new glass into position.
9. Bolt the front and rear sash channel nuts to the glass and reinstall all the other mechanisms in the door.
