Vehivle bumpers are the most exposed any of a vehicle and are susceptible to damage.
Plastic van bumpers oftentimes grow into damaged by other vehicles, remarkably in parking lots. While plastic has some flexibility, allowing it to recover its initial shape after a youngster collision, the whitewash that covers the damage eventually flakes off. This leaves an uneven Stop that detracts from the van's overall glimpse. Learned oppose shops can repaint the bumper at a great bill and it normally resources leaving the van with the protest acquire a sporadic days. Appropriateness a infrequent elementary target shop techniques to repaint a plastic bumper, saving means and allotment in the mode.
Instructions
1. Most bumpers are directly mythical from encounter resistant plastics.
Use 600-grit sandpaper. Wipe off the sanding debris with a clean rag and repeat the process until an even coat of primer is achieved. It usually takes two to three coats.
2. Mask off the field on all sides of the bumper with painter's masking tape. Concoct a two inch Broad edge on all sides of the bumper and any areas on the bumper that Testament not be painted, such as brake lights or metal trim. Capitalization aged newspapers to embrace the entire backside of the car. Create a Four foot spray barrier. During the priming and finishing process, spray paints will be used. Because the spray is difficult to control, paint can end up on surfaces not meant to be painted. The paper spray barrier prevents this problem.
3. Bumpers are incorporated into many car bodies, making them difficult to replace.
Sand the entire outer surface of the bumper with a palm sander. Start with 320-grit sandpaper. The entire bumper must be sanded; otherwise the paint will not adhere to the bumper's surface. Sand with 320-grit sandpaper until the entire bumper is smooth. The initial sanding removes the clear coat or lacquer, preparing the surface for painting. Lightly sand the bumper with 600-grit sandpaper. Wash the surface of the bumper down with liquid laundry detergent and hot water to remove any sanding debris. Allow the surface to dry thoroughly before proceeding To pace four.
4. Spray a thin coating of automotive primer onto the sanded bumper. Spray paint and spray primers works best when applied in thin, multiple coats. After allowing the primer to dry for Four hours, lightly sand the entire surface by hand.Wash the bumper thoroughly with liquid laundry cleanser and blistering damp. Blend Four teaspoons of liquid laundry cleaner to Sixteen ounces of blazing aqua. Dry the bumper completely before proceeding To pace two. To rapidity up the drying step, dust the washing bumper down with Disinfected rags. Spray the entire bumper rather than only the damaged areas.
5. Wash the primed bumper with soapy water and thoroughly dry it with clean rags. Spray a light coating of automotive paint onto the entire surface of the bumper. Allow Six to Eight hours drying time. Sand the bumper lightly with 600-grit sandpaper. Wipe the bumper down thoroughly with a clean rag and repeat the painting/sanding process until an even finish is achieved. Allow Twenty four hours drying time before proceeding To pace six.
6. Buff the painted area out, using a fine buffing compound designed for automotive finishes. This type of buffing compound evens out the finish and provides a protective coating for the newly painted bumper. Apply the buffing compound using a clean rag, working the rag in a circular motion.
