Repeat Steps Four and Five for the other bolts and nut. Allow the flanges to cool down before proceeding.6.
Instructions
1. Situate a turn block against the outer tread face of one of the front tires.
2. Lift the rear axle of the One thousand nine hundred ninety two Toyota Tercel with the jack and lower the vehicle onto jack stands. The stands should be placed under the rear rocker panels decent forward of the rear tires.
3. Situate on the safety goggles and gloves and crawl under the rear of the Tercel. Set the flange connexion of the inlet muffler pipe to the centre cylinder flange.
4. Heat lone the nuts of the elementary hardware one at a generation, holding the centre channel and muffler tube flanges calm with the torch. Wait for the kernel to turn blood from the heat of the torch.
5. Clout the intellect of the bolt attached to the heated seed with a metric box-end wrench and remove the nut with another metric wrench.The muffler on the One thousand nine hundred ninety two Toyota Tercel is flange-connected to the centre conduit. The muffler has a petty, welded hop-over main time located on its inlet that connects to the the flange of the centre conduit. Between the muffler and cylinder flanges is a gasket that can weaken over clock and fabricate a inconsiderable exhaust leak. The hardware holding the flanges cool is exposed to the high rise temperature of the exhaust action and other apparent elements, production it somewhat ball-buster to remove the gasket from the two-point flange connexion.
Remove the gasket between the flanges. Use the wire brush To cleanse off the rust and corrosion on the mating surfaces of each inner flange connection.
7. Apply a thin, even coat of the red high-temp perma-gasket compound to both sides of the ring muffler gasket and place it down, on either side, onto the small pipe extension on the center pipe's flange.
8. Place a flat washer on one of the bolts and place it down through the muffler flange. Repeat this step with the other bolt. Align the bolts and the muffler flange onto the center pipe flange.
9. Place a lock washer and a nut on each bolt bottom and tighten with the box end wrenches.
