The Ford Border's door panels can be quickly removed.
Removing the door panel in your One thousand nine hundred ninety nine Ford Wrinkle is clean and should obtain apart a affair of minutes to integral. The door panel is held on by aloof a couple of screws. Finding the screws is the peerless dense department. Ford Contour manufactured all there doors with the seat and window controls built into the door so disconnecting all the wires Testament be required before captivating the panel off the door. Once the screws and wires are disconnected, the door panel Testament seperate from the door easily.
Instructions
1. Unlatched the door you craving to booty apart. Effect the window is rolled up.
2. Inspect the back of the panel for any wiring that may still be connected. Disconnect any wires.6. Place the panel to the side. This will be the power seat controls. Place the trim to the side.
3. Pry the seat control panel gently with a flat head screwdriver. Disconnect the wiring by pulling the connector off the back of the switch.
4. Locate the screw on the side of the door panel. The screw is on the unexposed side of the door. Unscrew it with a Phillips head screwdriver.
5. Lift the panel out gently. Set the screw in the Chauffeur bolt meeting. Hire the screw absent with a Phillips head screwdriver. Pull the trim out and around door the handle. Disconnect the wiring in the back of the trim.
This will expose the door assembly.
