Wiring a horn the prerrogative hang-up, if to transform a non-working horn, or to install a contemporary one to a custom vehicle is a afafir that a competent do-it-your self type should be able to adequate in an age or two.
Instructions
1. Disconnect the bad terminal from the battery.
2. Using the self-tapping screw, mount the 20-amp circuit breaker in a protected point near the vehicle battery.
3. Adoption a length of 14-gauge primary wire with a bell terminal on the course breaker confine and an insulated solderless spade terminal of the relay extreme.5. Connect Pin 87a and Pin Eighty six with a short quota of 14-gauge wire, having a female solderless spade connector on Everyone extremity.
Connect one terminal on the circuit breaker to the skilled terminal of the battery, using a collection of wire and two solderless bell terminals.4. Connect the other terminal of the trail breaker to Pin Eighty seven of the Vocable Stat One hundred ninety two relay.
6. Mount the horn. Operate a exorbitant self-tapping screw, and mount to an field endure the bumper or grille.
7. Connect Relay Pin Eighty five with the terminal on the horn, using a length of 14-gauge wire with solderless female spade connectors on both ends.
8. Mount the momentary contact switch within easy reach of the driver.
9. Connect Relay Pin Thirty with a terminal on the momentary contact switch. Use 14-gauge primary wire.
10. Connect the other terminal of the switch to a metal part of the vehicle.
11. Reconnect the battery's negative terminal.
