Installing a intent lift Testament bestow your Durango a sporty cast extremely as better its handling when you obtain it off-roading, complete elevation roads or creeks. You commitment to lift your automobile’s item now the augmented clearance you hold the more suitable. The clearance from the ground is needed so that your vehicle's undercarriage does not drag on boulders and other items you may cross over.
Instructions
1. City your Durango in the garage or establish an unbolted elbow grease sphere that has regional foot traffic. Conceive confident you enjoy everything handy and a helper with you.
2. Adoption the jack to lift up the Durango on to jack stands moulding confident the tires are off the ground. Remove the wheels and then the front suspension including all the brake lines. Your new lifted Durango will need stronger brakes. Most lift kits should have everything that is required.
3. Get the back of the car on jack stands also and remove the whole suspension. What you have will not fit in so putting it to one side for later disposal would be a good idea. Change the brake lines as required and use all the clamps and holders that came with the kit.
4. Make sure you have the right springs for the front. Installation is tricky so follow all the directions that came with your lift kit. Put on the new wheels and bolt them in so they are tightly on. Using your floor jack remove all jack stands and get your vehicle on the ground. Drive the vehicle out of the garage to make the garage easier to clean up.
Install the springs after compression, putting the new shock absorbers in between. Installing the back suspension is easier than the front one because there is no steering mechanism to contend with. Everything is bigger now that your new lift kit is on.
6. Check what you have done. Make sure you have installed the brake lines, springs and shocks right, tighten all bolts. Then inspect everything again for accuracy.
7. Using the spring compressor install the new shocks which would be larger and stronger than the original. Install the springs as indicated and make sure the steering gear is installed correctly.5. After everything is removed and cleaned you are ready for a test drive.
