Continue to paint the part by applying the base coat according to the paint manufacturer's instructions. It is best to apply the base coat before the adhesion promoter has dried.
Applying the adhesion promoter solution with an HVLP paint gun
5.The adhesion promoter effectively replaces dye primer, so any surface imperfections should be corrected before handle. The adhesion promoter is available as a concept to be handle in air-powered tint guns besides as an aerosol spray.
Instructions
Using the aerosol can
1. Disinfected the apportionment to be painted with a grow and grease remover. Scour the surface with an abrasive cleaner or compound, then thoroughly rinse off the residue with a regular stream of H2O. Provided H2O Ambition on the surface, it should be scoured expanded until the soak comes off the constituent in sheets.
2. Dry the sphere to be painted. Alteration the effects to a picture booth and remove all dust with an air blower and a Hairpin cloth.
3. Spray on the adhesion promoter in yet passes until the complete constituent has been covered. Grant the adhesion promoter to shine dry for three to five minutes, then exercise a moment coat. Whether enough adhesion promoter remains in the can, add a third coat after the second coat has flash-dried for three to five minutes.
4.Bulldog Adhesion
Promoter streamlines the repainting system for Car refinishing.Bulldog Adhesion Promoter is a solvent manufactured by Klean-Strip that prepares plastic surfaces for the imitation coat of dye. The adhesion promoter is paragon for apply on plastics, such as bumper covers, that are Supple and gain beggared adhesion properties for automotive colouring.
Prepare the part to be painted as with the aerosol solution in steps One and Two above. If the part is not immediately going to get a base coat, mix one part adhesion promoter with two parts primer. Load the adhesion promoter into an air-powered paint gun and set the pressure to Thirty to Forty PSI, or according to the manufacturer's instructions for an HVLP gun.
6. Spray on two or three coats of the adhesion promoter, allowing it to flash dry three to five minutes between coats. If the adhesion promoter has been mixed with primer, more time may be necessary To admit it to set.
7. Load the paint gun with four parts base coat mixed with one part adhesion promoter. Mixing the two allows the adhesion promoter to behave as a flex agent on plastic parts. Apply the base coat according to the paint manufacturer's instructions.
8. Apply the clear coat mixed with adhesion promoter in a 4:1 ratio once the base coat is as dry as recommended by the clear-coat manufacturer. Apply as many clear coats as necessary and allow the part to completely dry.
