There are a scarce reasons that might crave the Bedstead Emigration of a pickup Motor lorry: the Bedstead might be rusted fini or damaged beyond repair and essential to be replaced, removing the Bedstead to access the fuel container or fuel lines for repair or upgrading to a dump Bedstead, For instance. While the brainchild of removing a Motor lorry Bedstead is not overly complicated, the bolts fastened to the Bedstead are exposed to the existence and may fabricate a measure of occupation to remove.
Preparing the Bed for Removal
Unbolted the Gauze fill door to the pickup Motor lorry and remove the retaining bolts to the plastic bezel. Remove the Gauze cap and then disconnect the ground strap. On many trucks, the ground strap may be attached to one of the retaining screws. Appliance a damp rag to comprehend the goose-neck opening of the Gauze vehicle. With the Gauze cap removed, you should be able to remove the goose-neck bezel.
Remove the tailgate. This Testament constitute the Motor lorry Bedstead that still lighter when it comes day to remove it. Contrasting types of trucks crave a slightly altered procedure to cook this. Nearly all tailgates pivoted at a 45-degree angle can be pulled off the hinge on the exactly hand side (the pivoted position aligns the ajar slot on the hinge and the tailgate's commemoration dowel) once the tailgate straps are disconnected. Once the hinge and dowel are aligned, pull up on the fly hand side of the tailgate, and it Testament pop off the left side retaining bracket.
While disconnecting the wire harnesses to the rear bright assemblies can be done underneath the Motor lorry, you can very simply remove the taillight assemblies and then disconnect the wire harnesses from up above.
Removing the wire harness from the licence plate flashing might be required on some models, on the contrary many trucks practice licence plate lights attached to the rear bumper. Equitable be undeniable there are no wires that are zip-tied to the protest of the Bedstead underneath.
Gun along the inside of the object of the Bedstead for any retaining bolts to the frame going down. Remove these bolts. Depending the build and mould of the Motor lorry, some of these bolts may hope for a definite factor such as a considerable Torx-head person socket.
Under the Bed
While this repair is yet easier to accomplish on a truck lift, it can still be performed by the home-auto-repair enthusiast. The largest problem you'll face is losing your leverage by laying on your back.Locate the retaining bolts holding the bed to the frame and remove them. Truck frames will feature access holes in the frame for the extension and socket to arrive the head of the bolts.Locate any other existing ground strap that may be attached from the bed to the frame and remove the differential breather tube if applicable.
Wear safety goggles because there will be a bunch of rust or other debris from the roads falling down on you.Pneumatic tools would help to remove the four to six (some may have eight depending on the length of the bed) undercarriage bed bolts; however, the downside is marring the head of the bolts. If they get rounded, you'll complicate the removal of them. A large breaker bar and a shallow socket with an extension would work best for the bolt removal.
Look up into the gas tank goose-neck chamber to make sure there is nothing else retaining it to the bed and that no damage will come to it once the bed is being lifted off.
Removing the Bed
Trucks beds can be easily lifted off the frame of the truck with four to six capable people. The bed is going to be heavy. Place one helper at each corner and if you have enough people, place another two at each wheel well. Lift the bed straight up. The person on the side of the gas tank goose-neck (most commonly the driver's side) will have to monitor the progress of the elevation of the bed to make sure it clears the goose-neck before moving the bed away from the truck.
While this can also be done with less people and different equipment; such as a bucket loader tractor or other industrial farm machinery, not everyone has access to this type of equipment.
