Do not move it away from the door yet, however.6. Disconnect the wiring from the door speaker by hand. Unplug the courtesy light bulb from the door by grabbing it and pulling away from the socket, perpendicular to the door panel itself.
Provided the window Engine fails, obviously, all the Press-stud pushing in the nature won't gratify your window to act at all. Whether this happens, you can transform the window Engine in approximately an lifetime provided you acquire basic automotive-repair doing and the conscientious tools.
Instructions
1. Pry the sail panel trim off the door using the trim tool, Stirring from the top down. The sail panel is the triangular-shaped trim last the mirror.
2. Pry the window switch bezel elsewhere with the trim baggage and disconnect the wiring harness from the switches by participation. Pry the lock encompass outside with the trim object.
3. Pry elsewhere the inner door hilt bezel plate with the trim tool. Pull it off the door handle by hand.
4. Remove the fastener behind the window switch bezel with the socket set and then remove the fastener in the door pull handle as well.
5. Grab the door panel and lift it up and off the door.Change a Window Engine on a One thousand nine hundred ninety nine SilveradoThe window motor in the One thousand nine hundred ninety nine Chevrolet Silverado pickup Motor lorry moves the window regulator in response to the Order of the window switch. Provided you push the switch up, the Engine then moves the regulator infiltrating which pushes the window glass up. Whether you push down, the antagonistic occurs.
7. Lift the window glass to the full upright position and then stick packing tape to the outside of the glass. Run the tape up and over the door frame and down onto the inside of the glass to hold the glass up while you replace the motor.
8. Unbolt the motor from the window regulator and the door using the socket set. Disconnect the wiring harness from the motor by hand.
9. Pull the motor out of the door by hand, insert the new motor and bolt it to the door and window regulator with the socket set. Connect the wiring harness to the new motor by hand.
10. Reinstall the door panel in the reverse of how you removed it. Peel the packing tape off the door glass.
