Removing a automobile's drive shaft is easier than you might envisage. A rare steps contain procedures needed for most rear turn coerce cars. Manipulate the succeeding steps to receive fini the manner quickly and on to the attached period of your project.
Instructions
1. Produce decided motorcar is on a Apartment lodgings surface, tires are blocked off and the emergency brake is engaged. This will prevent the car from moving during the procedure.
2. Place the floor jack under the rear differential of the car. Jack the car up to the desired work height. Put jack stands under the frame for extra precaution in the event that the floor jack fails.
4. Remove bolts. Carefully lower the drive shaft to the ground without disturbing the U-joint bearing caps.
3. Refer to your car's manufacturer's manual to locate the rear drive shaft. Loosen nuts at the U-joint where the drive shaft connects to the yoke. Repeat at the other end.
5. Wrap electrical tape around the exposed caps on the U-joint to prevent them from falling off.
