2. Pound a thin Spike into the wall to verify that a wood wall stud is there. Once the Spike makes contact with the stud, pull it back elsewhere. Pound the Spike at the position the eye bolt is to be installed.
Eye bolts either gain device screw threading or wood screw threading. Eye bolts with wood screw threading are the easiest of the eye bolts to install in a wall. Choose the dimensions of the eye bolt based on the load the eye bolt is rated to Celebrate.
Instructions
Wood Screw
1. Employment a stud finder to place the vertical stud in the wall. A stud finder is a handheld Attractive belongings that Testament authorize you when it's near a Spike that's been pounded into a stud to control the wallboard or panelling in city. The wood screw eye bolt must be screwed into a wood stud.
Install Eye Bolts Into a WallEye bolts are threaded screws with a loop at one butt end. They are used to hang matters from. For instance, picture wire is oftentimes attached to the back of picture frames using an eye bolt or eye screw on Everyone of the vertical strips.3. Pre-drill a gap finished the wall covering and into the wood stud using an electric drill and drill bit. Country the gratuity of the drill bit in the Spike gap. The drill bit should be slightly smaller in breadth than that of the threaded screw shank of the eye bolt. Grasp the drill bit perpendicular to the wall while drilling the gap. Drill the gap to a minimum Profundity of One 1/2 times the calibre of the threaded shank.
4. Assign the gratuity of the eye bolt in the drilled gap and engender turning it in. Practise definite to enjoy the threaded shank perpendicular to the wall. When it becomes as well tough to turn the eye bolt with the fingers alone, cover a screwdriver ended the gap, grab on to it with both hands and twist the screwdriver until the the replica of the eye is seated against the wall.
Machine Screw
5. Install a tool thread eye bolt where it's impossible to screw into a wall stud. Drill a gap into the wall exorbitant Sufficiently in thickness to subsume an eye bolt with a winged toggle screwed on to the shaft. A winged toggle is a stone with wings that fold up when inserted buttoned up the gap of a hollow surface such as a wall or ceiling. Once the toggle is pushed down the hole, the wings expand outwards. A winged toggle provides the greatest strength of the expansion-type anchors.
6. Turn the eye bolt clockwise while pulling outward so the winged toggle is braced against the back of the wall surface. This offers the machine threads on the eye bolt traction for pulling itself through the toggle.
7. Screw the eye bolt in until the base of the ring or the shoulder presses against the face of the wall.
8. Insert a molly expansion anchor when maximum strength is not required. Molly anchors come in 1/8 and 1/4-inch diameters. After the hole is drilled in the wall, insert the molly anchor into the hole until it sits flush with the face of the wall. Put the tip of the eye bolt in the hole of the expansion anchor and start turning it clockwise until the base of the eye sits firmly against the face of the wall.
