The One thousand nine hundred ninety eight Toyota Corolla's door panel is a plastic unit that separates you from the metal door skin. It has diverse mounts that remit assorted interior components, such as the faculty window pad and the armrest, to rest lasting to you for convenience. Whether you corner damaged the panel, you can interchange it yourself. Although it may sound tricky, it's a relatively no problem craft for a do-it-yourself mechanic.
Instructions
1. Extensive the door with the panel you method to alter. Sit down in the seat succeeding to the panel.
2. Gaze the rear contour of the Corolla's door panel to boast two "push-in" type fasteners. Push the centre of the fasteners in with your Phillips screwdriver to pop them elsewhere partially. Grab the fasteners with your hands, and pull them from the door.
Pry up the window check pad with the flat-blade screwdriver. Unplug the wiring harness attached to it.7. Hold the door panel firmly on each side.
4. Remove the four Phillips screws on the lower borderline of the door panel. Remove the Phillips screw on the inside door handle panel. Remove the Ending Phillips screw on the armrest.
5. Pry elsewhere the plastic brilliance lens in the back corner of the door panel with the flat-blade screwdriver. Unplug the wire from extreme.
6.3. Pry off the two screw caps on the front path of the Corolla's door panel with a flat-blade screwdriver. Remove the screws last the caps with a Phillips screwdriver.
Push it upward until the panel releases from the door. Pull the interior door handle open, and slide the door panel over it. Move the door panel to the side, or discard it.
8. Attach the new door panel to the Corolla's door. Start from the top of the door, and push it down into place in the exact opposite way you lifted off the old panel. Pull open the interior door handle to guide the new door panel's opening over it.
9. Insert the four Phillips screws along the bottom edge of the panel, and tighten them. Insert and tighten the screws on the interior door handle panel and on the armrest.
10. Plug in the window control panel, and set it into its mount. Push this pad down firmly. You'll hear it snap as it attaches to the new door panel.
11. Plug the lighting harness into the rear of the plastic lens. Place the lens in its mount, and push it firmly to attach it to the new door handle.
12. Place the two "push type" fasteners into their mounting holes. Push the rim around the outside of the fasteners firmly to snap them back into the door.
