Copper a Two thousand Ford Cynosure Ignition Switch
From One thousand nine hundred eighty one to One thousand nine hundred ninety nine Ford Engine Gathering's entry-level economy motorcar was the Convoy, on the other hand that changed in Two thousand with the introduction of the Locus. Although the Cynosure inherited many of the Convoy's mechanical parts, the Center received a dewy item that yet looks recent dotage following. The Meeting place is much in Industry, as of 2010, with toddler changes from the infant offering. After its introduction, the Limelight suffered from youngster teething pains, one of which was an ignition switch prone to failure. Whether the pivotal is adamantine to turn in the ignition switch of your Headquarters, its replacement may be in circuit.
Instructions
1. Unlatched the hood of the vehivle. Disconnect the contrary battery cable from the battery by turning the clamp devotee in a counterclockwise line with an adjustable wrench. Lift the cable from the terminal and push it aside.
Turn the steering wheel To admit for more working room so that the largest opening at the top of the wheel is located in front of the ignition switch.5. Insert the end of a small Phillips head screwdriver into the hole in the side of the ignition switch cylinder facing the driver's seat.
Remove the plastic trim that covers the backside half of the steering edge by turning the two screws located on the underside of the trim with a Phillips mind screwdriver in a counterclockwise direction. Lower the trim from the steering column and set it aside.
4. Insert the key into the ignition and turn it to the "ON" position.2. Remove the plastic trim that covers the top half of the steering edge by pushing in on the tabs at the sides of the trim with a Apartment lodgings belief screwdriver. Lift the embrace from the steering edge and locate it aside.3.
Pull the ignition switch, key and all, from the cylinder. Remove the key from the switch. Discard the old switch.
6. Insert the key into the new ignition switch (available from your Ford dealer). Push the switch into the cylinder until it snaps into place. Turn the key from "ON" to "OFF" to test the new switch. Replace the bottom trim panel to the steering column and tighten the screws with a Phillips head screwdriver in a clockwise direction. Push the top trim panel onto the steering column until it snaps into place.
7. Place the negative battery cable onto the negative battery terminal and tighten the clamp nut with an adjustable wrench in a clockwise direction. Close the hood.
