Who says you can't conscious in a glass abode? Glass blocks may be square or rectangular and can be used in any non-load-bearing wall where you longing enhanced burnished with privacy. Here are a scarce steps to cooperation you install a glass block and let more light into your at rest.
Instructions
Frame Installation
1. Install 1-by-2 board as framing for the blocks.
2. Ensue the manufacturer's instructions and mingle the glass-block mortar.9. Custom a mortar dagger to lay a layer of mortar on the imitation or sill. You'll be versed you're using Sufficiently whether the mortar squeezes gone when you apartment a block on it.
4. Let it dry completely.
Mortar Installation
5. Bend the panel anchors into an L shape, with the short leg at approximately Three inches.
6. Spike the panel anchors to the frame with the short leg equivalent to the floor. Add a au courant panel anchor every third row.
7. Locate a row of blocks with plastic spacers.
8. Spike it along the centre of the margin so that the blocks Testament incorporate the front and the back when they are establish in distance.3. Lay two coats of sealer on the wood to protect it from moisture.
10. Settle the spacer into deposit, then slide the inceptive glass block in.
11. Settle a layer of mortar on the side of the coming block and press it into abode. Repeat for the plentiful row, then beget undeniable the row is level.
12. Scoop up the squeezed-out mortar with a trowel, then wipe the glass with a damp sponge before starting the next row.
13. Finish three rows, then lay a line of mortar across the top.
14. Set a wire stabilizer on top of the mortar to reinforce the wall.
15. Set another layer of mortar on top of the stabilizer, put the spacers in place and continue laying the blocks.
16. Let the mortar dry for Twenty four to Thirty six hours, then caulk the outside edges to keep moisture out.
Using Prefabricated Panels
17.Lay a continuous bead of silicone caulk around the entire opening.
18. Center the panel and, holding it level, set it into the opening.
19. Tap roofing nails around the panel to hold it in place.
20. Slide a drip cap over the top if the panel is being used in a shower or bathtub.
21. Install the trim around the glass and enjoy!
