Repairing a leaky sunroof normally leads to discovering that the sunroof is not the culprit of the leak. Instead dirt and debris may be the viable culprits in that they choke the drainage tubes or the bleed channel that are atom of the sunroof's bathe control transaction. Once these are obstructed, the douse backs up and heads for the nearest escape, which may be to the interior of your automobile.3. Mop and Disinfected the trough that is approximately the opening of the sunroof. Manipulate a wet cloth to remove any debris that may be preventing a tight seal between the trough and the sunroof's seal.4.
Custom a non-abrasive cleaner with a soft cloth To cleanse the glass panel and the seal on the gone of the automobile.
2. Unlocked the sunroof after opening the vent Screen. Spare the sunroof to plain to the vent position on the other hand close not let it slide backwards.
The closest directions are to facilitate you repair a leaking machine sun roof.
Instructions
1.See the seal. Cast for any cracks in the seal. Provided you good buy any, you will need to replace the seal. Contact the car manufacturer or a repair shop to replace the seal.
5. Check the drainage tubes. You can use a small cable or even a coat hanger to gently probe around for a few inches to see if there are any clogs or standing water in the tubes.
6. Use a thin cable or coat hanger wire again to try to clear the drainage tubes if they are clogged. Make sure whatever you use does not have a sharp end and apply only a little pressure.
7. Verify that any of the standing water in the drainage tubes went down by poking a dry thin cable or wire down an inch or and pulling the wire back out.
8. Check that the clogs are completely gone in the drainage tubes by pouring a small amount of water into the tubes.
