When you effect to existence a periodic "click" when you turn the ignition pivotal in your One thousand nine hundred eighty eight Ford Convoy, you may get a failing starter. You should interchange a evil starter prerrogative elsewhere to avoid a telephone to the Car club whether it Last of all gives away completely when you're on the pathway. Many Car parts stores Testament research your starter for you whether you remove it from the vehivle and bring it in. You can exchange the starter in your Convoy easily in your own driveway. Acquire a original starter from an Car parts retailer or Ford dealership.
Instructions
1. Remove the two mounting bolts from the front of the starter Engine. Support the starter body with one hand while you remove these bolts with a socket and ratchet. Pull the starter body out of the engine compartment.
Remove the jack when the jack stands are secure. You Testament exigency to be able to bullwork under the Convoy to access the starter.
3. Slide under the Convoy and place the starter. Remove the wiring harness from the starter. Lift the retaining clip and pull the electrical connexion elsewhere from the harness.
4. Remove the two bolts securing the rear mounting bracket to the starter, using a socket and ratchet. Remove the kernel from the rear of the starter, using a socket and ratchet, and remove the mounting bracket.
5. Up thrust the hood of your Convoy and disconnect the dissension battery cable with a wrench. Isolate the cable so it does not contact the battery terminal while you are working.2. Lift the front of the Convoy with a jack and bed it on a fix of jack stands.
6. Line up the new starter motor and secure it by hand-tightening the two front-facing mounting bolts. Then securely tighten the bolts with a socket and ratchet. Attach the rear mounting bracket and secure it with the two rear-facing mounting bolts. Tighten the bolts with a socket and ratchet. Replace the nut on the rear of the starter body and tighten it with a socket and ratchet.
7. Reconnect the electrical connection on the starter body. Press the connection into place until it clicks, locking into place.
8. Raise the car slightly with the jack so you can remove the jack stands. Lower the car to the ground and remove the jack. Test the operation of the new starter.
