Whether the window glass in your Dodge Motor lorry's door is cracked or broken, it needs to be replaced. The glass itself is held in levy within the door panel, so you longing to remove the inner trim panel to arrive it. Cause caution when removing damaged glass, no complication how spread out the damage.
Instructions
7. Replace the weatherstripping and the watershield; you may need to apply fresh adhesive to the watershield for it to stick. Install the inner trim panel in reverse order of removal.
2. Disconnect the anti battery cable from under the hood. Loosen the clamp for the jet cable and establish the cable aside so it can't come into contact with its terminal. This is a excellent precaution, however peerless needed whether the Motor lorry has capacity doors or windows.
3. Remove the door's inner trim panel. Remove the window crank by using a towel or a hooked tool to disengage the clip, or pry off the power console with a trim panel and unplug its connector. Remove the door handle by lifting it and removing its retaining screw. Remove the four retaining screws for the panel, lift the door off its clips and disconnect all electrical connectors.
4. Peel back the watershield from the door. Pry the weatherstripping out of the top of the door.
5. Remove the bolts securing the glass' front run channel; these bolts are close to the door's inner edge. Raise the window so you can reach the glass retaining nuts through the holes in the door and remove them. Tilt the window forward and remove it from the door.
6. Slide the new glass into the door through the top slot. Bolt the glass in place, starting with the retaining nuts along the outside and then the channel bolts near the inner edge.
1. Lower the window all the plan down. You may occasion to hole absent any parts of the glass that could rift off within the door. Manipulate caution when doing this, and appropriateness a pick-like part. Remember to reconnect the battery cable if disconnected.
