Transform an Alternator on a '96 Altima
The One thousand nine hundred ninety six Nissan Altima was available single with the 2.4 litre four-cylinder engine. Unlike many other automotive designs, the Altima's engine sits sideways in the engine compartment. Happily, the engine's alternator is located on the front of the passenger's side of the engine, forging access accessible. Provided the machine's battery is in acceptable occasion much always needs recharging, chances are choice that a latest alternator Testament solve the crunch.
Instructions
Removing the Alternator
1. Disconnect the dissension battery cable from the battery with a wrench.
2. Remove the radiator cap after allowing the engine to frigid, then loosen the petcock withdraw plug at the replica of the radiator with a wrench and let on the radiator to empty until the fluid aligned inside the radiator has fallen below the upper radiator hose.
3. Loosen the clamp which secures the upper radiator hose to the engine with a screwdriver, then pull the hose from the engine to access the alternator.
4. Loosen the alternator's three fasteners with a wrench to slacken its sash. A unmarried bolt is located on the back of the alternator. A unmarried stone is located on the top of the alternator's mounting bracket equitable above the pulley. The Ending fastener is the adjusting bolt, which is located between the alternator's pulley and its mounting bracket.
5. Pull the alternator's girth off the alternator pulley.
6. Disconnect the alternator's two wiring harnesses from the top of the alternator by pulling the harnesses from the alternator.
7. Remove the alternator's three fasteners that were loosened in course 4, then lift the alternator from the engine.
Installing the Alternator
Plug the alternator's two wiring harnesses onto their respective Trimmings on top of the alternator.10. Position the girdle onto the alternator pulley, then tighten the alternator's adjusting bolt, located between the alternator's pulley and its mounting bracket, with a wrench until the alternator zone is tight.11.
8. Position the alternator onto the engine and hand-tighten Everyone of the alternator's three fasteners into the alternator.9.
Tighten the alternator's two remaining fasteners, context the bolt on the back of the alternator and the follower on the top of the alternator's mounting bracket good above the pulley, with a wrench.
12. Position the radiator hose onto the engine and tighten its clamp with a screwdriver.
13. Fill the radiator with coolant until unabridged and install the radiator cap.
14. Attach the abrogating battery cable to the battery.
