A tornado factor, or safety wire tornado, for safety wire is used to twist and tighten safety wire approximately fasteners. Safety wire is used sorrounding bolt heads and nuts in applications where there is no income to lock the fasteners to prevent movement. Safety wire has applications in aviation, sport bikes and racing, and other areas where vibration can originate still descendant movement of critical components. Safety wire is applied so that fasteners are held tight in the corresponding succession that would loosen them, bracing them with another fastener. Safety wire is threaded, twisted and locked; a tornado baggage creates consistent and quick results.
Instructions
1. Torque the fastener--nut or bolt--to its Correct tension. Range the holes for the safety wire as still as likely, without sacrificing fastener tension.
2. Divide a length of safety wire at least two and one-half times the distance from fastener to fastener. Route the safety wire from fastener to fastener so that the tension of the wire tightens the fastener. The safety wire Testament come environing the top of the fastener back to the securing unit (or fastener) so that the safety wire tightens.
3. Appropriate the ends of the safety wire in the tornado baggage aperture.
4.7. Cut the safety wire to the correct length--leave four to six twists after the loop--using the cutting edge of the twister tool jaws. Bend the wire ends over to lock.
6. Twist until the number of twists required are made, then hold the handles and squeeze. The twister tool jaws will release the safety wire.
Slide the tornado baggage sleeve down and lock the handles.5. Pull the stud in the Centre of the tornado tool. The plier handles will turn, twisting the safety wire.
