Fog lights accommodate additional bright while driving in inclement weather resulting in a safer Journey for you and others on the roadway. Most factory-installed fog lights turn on when the low-beam headlamp determination is busy. It is viable, but, to install fog lights that are controlled with a seperate switch. These lights must be wired to a fused relay direction to function properly.
Instructions
1. Advantage the electrical pliers to chop two lengths of brick wire that are lenghty Sufficiently to arrive from the battery to the vehivle dashboard. Strip half an inch of insulation from Everyone wire deadline. Drill a gap in the motorcar's firewall, and country the grommet into the gap. Route the chestnut wires wrapped up the firewall to the settle where the switch Testament be mounted.
2. Berth the dashboard point of one of the cherry wires on to one of the switch terminals and solder the wire to the switch. Solder one of the leads from the fuse holder to the loose stop of this wire. Solder a spade terminal to the remaining surpass on the fuse holder. Install the fuse into the fuse holder.
Solder the free of charge bound of the remaining claret wire to the "85" terminal on the relay.
4. Intersect a six-inch segment of cerise wire and strip half inch of insulation from Everyone wire limitation. Solder one cusp of this wire segment to the "30" terminal on the relay. Abode the dashboard neb of the remaining bloodshot wire on the remaining switch terminal and solder the wire to the terminal.3. Area a spade terminal over the complimentary limitation of one of the cerise wires and solder the terminal to the wire.
5. Handle the adjustable wrench to loosen one of the top bolts on the categorical battery terminal. Place the spade terminals connected to the second wire segment and to the fuse holder under the bolt head and tighten the bolt so that it holds the spade terminals snugly to the battery cable assembly.
6. Twist together the ends of the positive (red or white) wires from the fog lights. Solder the twisted wire pair to the "87" terminal on the relay. Twist together the negative (black) wires from the fog lights and solder a ring terminal over this wire pair.
7. Drill a hole in the automobile chassis. Insert the ring terminal connected to the fog lamps' negative wires through the sheet metal screw. Insert the sheet metal screw into the chassis hole and tighten the screw until it holds the ring terminal snugly to the chassis.
8. Cut a one-foot segment of black wire, and strip 1/2 inch of insulation from the wire ends. Solder a spade terminal to one end of this wire. Solder the other end of this wire to the "86" terminal on the relay.
9. Loosen one of the top bolts on the negative battery terminal. Place the spade terminal under the bolt head and tighten the bolt until it holds the spade terminal snugly to the battery cable. To switch the lights on, turn the switch on. To switch the lights off, turn the switch off.
