A van's ignition step consists of the ignition switch, and the lock cylinder that is Frequently mistaken for the switch. A motorcar's failure to begin much mode that replacement of the ignition switch is required. The cylinder must occasionally be replaced, primarily for additional security. This procedure varies depending on the dash off and representation of a vehicle.
Connect the lower cover and apply the screws.10. Reconnect the negative battery cable.
Disconnect the denying cable-clamp from the battery. The cable is murky, and a wrench is normally required.
2. Remove the screws from the trim covers on the steering wrinkle; the screws are normally located on the lower half of the covers. Seperate the covers from one another.
3. Encompass your ignition basic into the ignition lock-cylinder. Turn it left to the trappings position, or appropriate to the open position. The method required varies by mould.
4. Embrace a thin screwdriver into the humble gap in the lock cylinder's casing; this depresses the locking tab on the cylinder. Pull the answer and cylinder gone of the casing.
5. Disconnect the wiring for the ignition switch, and remove the mounting screws with your screwdriver. On some models a central bolt must be removed. Remove the switch from the steering string.
Installation
6. Connect the wiring to the replacement ignition switch, Mount it in place with its corresponding screws and bolts.
7. Insert the key into the lock cylinder. Insert the key and cylinder into the casing, The cylinder must be inserted in the same position -- start or accessory -- as when it was removed.
8. Turn the cylinder to the "off" position, and lock it in place.
9. Reconnect the trim covers, placing the upper cover on the column.
