The One thousand nine hundred ninety six Toyota T100 pickup starter Engine is located on the Chauffeur's side of the engine, attached to the call housing near the back of the engine. Whether your starter is not working or is skipping, dragging or forming grinding noises, it may be age for a original starter Engine. Elementary, bench corroboration the starter absent of the T100 to fix upon its occasion. Most Car parts stores Testament bench countdown your starter free whether you remove it.
Install the wire on the stud terminal on the starter, followed by the retaining nut. Tighten the nut with a socket and ratchet.6.
To avoid a short or injury, isolate the battery cable so that it can't accidentally touch the battery announce while you are working on the electrical components and starter.
2. Jack up the front of your T100 and position a allot of jack stands under the front of the Motor lorry to agency it. Slide under the Chauffeur's side of the engine and set the starter.
3. Remove the electrical wiring connectors from the starter. Push in the locking tab on the push-in connector and pull the connector from the terminals on the back of the starter. The moment terminal is a stud with a wire and devotee on it; employment a socket to remove the seed, then slide the wire off the terminal.
4. Remove the upper and lower mounting bolts on the nose of the starter while supporting the starter by participation to deal in it from falling when it becomes loose. Remove it. Lift the original starter up and into the spot where the mature starter came absent.
5. Install the two mounting bolts in the nose of the dewy starter and tighten them with a socket and ratchet.
Instructions
1. Govern the hood and disconnect the contravening battery cable from the antagonistic battery post using a wrench.Install the plug-in connector on the terminals of the new starter. Push the connector onto the terminals until the locking tab snaps into place. Raise the front of the truck with a jack to remove the jack stands from under the truck, then lower the truck to the ground.
7. Install the negative battery cable onto the battery terminal and tighten the retaining bolt with a wrench.
