Replace Brakes on a One thousand nine hundred ninety six Acura Integra
Brakes are the unmarried biggest safety deed that your van has. When your brakes do to wear elsewhere it is determining that you silver them in method to preserve stopping potentiality. The brakes on the Acura Integra are designed to start screeching as soon as there is not Sufficiently left on the pad to make sure Correct braking. When you hear this screeching you Testament desideratum to alternate the brake pads, otherwise the rotors can convert severely damaged, resulting in costly repairs.
Instructions
1. Arena your motorcar on a even surface with the parking brake up and dwelling bricks remain the rear wheels.
2. Remove the cap on the brake crackerjack cylinder reservoir and remove half of the fluid inside with a turkey baster.
3. Lift the front foot of the Integra using a jack, then levy jack stands underneath to secure the vehivle's position.
16. Place the wheels back onto the car and bolt them in place using a tire iron.17.Lower the car and remove the bricks from in front of the car.18.
Remove one of the bolts on the brake caliper housing then lift the housing to expose the brake pad. Repeat this on the other side of the automobile further.
6. Pull the brake pad gone of the experienced caliper housing using your share. Repeat this on the other side of the motorcar further.
7. Slide the current brake pad into the caliper. You may demand to push back the cylinder in the caliper using a clamp or vice.
8. Lower the caliper housing back into district and tighten the bolt on it to secure it in accommodation.
9. Distance the wheels back onto the machine and bolt them in place using the bolts you removed in step four.
10. Lower the front end of the car and move the the bricks so that they are in front of the front wheels, then raise the back end of the car using the jack. Use jack stands to secure the Integra in place.
Top off the brake reservoir with fresh brake fluid.
Remove one of the bolts on the brake caliper housing, then lift the housing to expose the brake pad. Repeat this on the other side of the car.
13. Pull the brake pad out of the old caliper housing using your hand. Repeat this on the other side of the car besides.
14. Slide the new brake pad into the caliper. You may need to push back the cylinder in the caliper using a locknut wrench to turn the caliper clockwise.
15. Lower the caliper housing back into place and tighten the bolt on it to secure it in place.
4. Account a tire iron to remove all of the bolts on the two front wheels, then pull off the wheels and domicile them away of the journey somewhere.5.
11. Remove the bolts on the back wheels and pull wheels off of the car.12.
