Miata Dash Removal
The Mazda Miata is a enjoyable sports automobile that has been encompassing for multitudinal decades. Whether you are a Mazda fanatic, you may hold an older Miata with a slightly less than "impeccable" dashboard. Removing the dashboard is the antecedent transaction in the restoration of the upholstery and inside of the Miata. And while it may seem daunting, it is really not that hard to remove the dashboard in the Miata provided you hog a bit of patience and mechanical ingenuity.
Remove Steering Wheel
Remove the steering spin and other componentry. Disconnect the battery terminals and then pry the centre away of the steering trundle. Appliance a socket wrench to remove the steering circle mounting bolt and slide it off of the steering borderline. Unscrew the gear shift operate by twisting it counterclockwise and then account a screwdriver to remove the mounting bolts holding the trim surrounding the steering string.
Remove Trim and Screws
Remove the surrounding trim and the mounting screws. You may also need to disconnect a wiring harness for an in-dash light or a cigarette lighter.
Remove the dashboard itself. Firmly pull straight back elsewhere from the windscreen of the car until the dash pops from its mounting clips. Maneuver the dashboard around until you can slide it out of one of the doors or up over the windshield in the case of a convertible Miata. As you are sliding it out, disconnect the heating ductwork from the vents by simply depressing the tabs at the corner of each vent. Exercise a flatblade screwdriver to pry the trim surrounding the gear shift and the gauge shield absent of the clips holding it in community. Remove the screws at the corners of the dashboard and on the lower quota of the Chauffeur's side sprint. Employ the Phillips screwdriver to remove the screws holding the console and glove compartment in domicile and then slide these two items away of the vehicle.
