Provided your motorcar doesn't come with TV sets installed in the front-seat headrests for back-seat viewing, you can install such TV sets yourself. You Testament obtain to chop holes into the headrests to install the TV, which could void you vehivle's warranty. And this might be prime left to a known at an electronics store or Car protest shop. A complete headrest TV place should come with the TV itself, the frame it rests in, an audio/video console and the wires to associate everything.
Instructions
1. Remove the headrest from the vehivle seat. Remove the upholstery embrace from the headrest to disclose the foam cushioning underneath. Hint the wrinkle of the TV frame on the rear side of the foam with a permanent marker.
2. Intersect into the foam with a razor cutting edge, digging it to the duplicate Profundity as the TV frame. Cutting the foam away in pieces may cooperate. Habitat the frame into the gap to proof how hearty it fits. Remove the frame and whittle outside the foam until the frame can fit securely in the foam.
3. Utilize contact cement along the inner bowl of the gap and the out ends of the TV frame (not the inside of the frame, where the TV fits). Assign the frame in the gap while the cement is wet, wait for the cement to locate and push the frame to fully stick it inside the gap.
4. Fix the gap in the frame where the TV's cable Testament energy finished. This box connects peripherals like headphones and an external DVD player. This box can be stored underneath the front seat and the cable connecting it to the TV can run under the seat's upholstery.8. Connect the power source cable to the console.
You can use more contact cement to glue the upholstery edges to the edges of the frame.
6. Place the TV screen into its frame. Make sure all contact cement has dried and hardened before you do this. Send the cable through its exit hole and through the headrest foam, then store it near the bottom edge of the upholstery so it can connect to the A/V wires.
7. Connect the TV to its audio/video console. Poke a gap finished the foam all the way to the headrest front, using a large screwdriver, so the cable will be able to go through it.5. Slip the upholstery back on the headrest. Cut away the upholstery where it is over the hole.
This can be a plug into the car's lighter adapter, or it can connect directly to the car battery. The kit should have all the instructions on wire the connections.
