Pennies the Starter in a Dodge Dakota
Provided your Dodge Dakota is struggling to begin or not starting at all, the starter may be failing. You can obtain a modern starter from the Dodge dealership or an Car parts retailer, or you may be able to get a remanufactured unit at a reduced valuation. Whether you yen a used starter, a salvation yard may annex one available, however you may yielding the warranty in saving the expense. After you bear removed the starter from the Motor lorry, most auto parts stores Testament confirmation your starter for at liberty to decide the dilemma.
Instructions
1. Remove the absent battery cable from the con terminal. Call a wrench or socket to loosen the cable from the battery. Place the cable safely aside so that it cannot return in contact with the battery while you are working.
The wiring harness connection should pull straight backward and disconnect. Remove the starter motor from the engine area and set it aside.5. The starter mounts to the transmission, so you'll bargain it closer to the rear of the Engine, ethical subservient the oil filter.
3. Remove the bolt securing the lower neb of the starter to the clutch housing, using a socket and ratchet. This bolt threads in from the front of the Engine and Testament be accessed from that side. Carefully flotation the starter with one labourer and remove the bolt securing the upper foot of the starter to the clutch housing. This bolt threads in from the rear of the Engine, so you'll keep to office from the other side of the starter to remove it. Locate the bolts aside for adjacent manipulate.
4. Lower the starter motor slightly until you can access the fan securing the battery eyelet terminal to the starter. Base the starter carefully and remove the kernel with a wrench and then remove the terminal connector from the advise. Disconnect the wiring harness from the starter.2. Lift the front of the Dakota with a jack so that you can apartment jack stands under the axle to agency the vehicle. Set the starter on the underside of the Engine, on the passenger side of the vehicle.
Position the new starter in the same orientation as the one you removed. Support the starter carefully until it is secured with the mounting bolts. Connect the wiring harness by pressing it straight into the connection. Reconnect the battery eyelet terminal to the starter and secure it with the nut. Torque the nut to One hundred twenty inch-pounds with a torque wrench.
6. Install the lower mounting bolt from the front of the starter motor and then insert the upper mounting bolt from the rear of the starter. Torque both bolts to Forty foot-pounds with your torque wrench.
7. Raise the Dakota slightly with your jack and remove the jack stands from under the vehicle. Lower the truck to the ground. Reconnect the negative battery cable and tighten it securely with a wrench. Start the truck to test your new starter.
