Make sure they are free from burrs and nicks. Torque to Fourteen foot-pounds.6. Open the motor's drain plug, which is located on the Polaris Five hundred motor, and allow the motor to drain into the oil pan.
Instructions
1. Prompt a hydraulic jack or arena your Polaris ATV on a constant surface for the oil quarters. Assemble positive you acquire a commendable lustrous source and a scorching group of Floor-mat to corker on provided no lift is available. Dart the engine for a unusual minutes, then shut it off.
2. Take off the left plastic side panel and check the oil condition and level. Open the dip stick and wipe it off with your shop rag. Set it back into the hole without screwing it down and pull it out again to receive an accurate measurement.
3. Locate the oil tank drain and motor drain and wipe them down. These are located under the oil tank and under the motor.
4. Place an oil pan under the oil tank, remove the drain plug from the oil tank and allow the oil to drain from the tank completely.
5. Replace the sealing washer and reinstall the drain plug on the oil tank.
So you'd agnate to convert the oil on your Polaris ATV and you envisage it can't be that even differential than changing the oil on a automobile. You're hold up, on the contrary there are due a unusual subtle differences in draining the oil on your Polaris than on your machine. Here's remove the oil the conscientious course on your Polaris ATV.This way you are assured you are not mixing old oil with new.
7. Find the screen fitting on the bottom of the oil tank and remove the oil hose from it. Clean the screen and apply the thread sealant recommended by the manufacturer and reinstall.