This Forenoon you hopped into your van equal to recite the starting step acting up, slowly cranking the engine or not much functioning. After a careful inspection of the manner, you admit confident it is day to obtain elsewhere that starter Engine for a lasting question. So here we Testament displace a accepted procedure with apparent however primary steps that Testament facilitate you remove the starter from your vehicle in a affair of minutes.
Instructions
Make sure to mark or label these wires so they can be reconnected later at their respective terminals.6. Remove the battery cable from the starter motor.7.
3. Alteration out or remove any any that might prevent you from reaching the starter motor.
4. Remove the heat shield or bracket protecting the starter if any. Place aside any removed part along with its bolts or nuts if possible for easy identification and quick re-installation.
5. Disconnect the wires from the solenoid if it is mounted on the starter motor.1. Disconnect the cable from the contradiction battery terminal using a wrench or ratchet and secure the cable out from the useful terminal.2. Lift the front of the vehicle with a floor jack and locate it safely on a yoke of jack stands for bedding.
Loosen the bolts or nuts that secure the starter motor to the engine or transmission bell housing. At this point, it is very important to make a note of the exact location and number of shims, if any, placed between the engine and the starter motor. Shims help adjust the distance between the pinion gear and the flywheel ring gear. Without these shims, the gears may be damaged.
8. Firmly hold the starter motor as you finish taking out the bolts or nuts that attach the motor to the engine. The starter is somewhat heavy.
9. Take the starter motor out of the engine compartment. To replace the starter, follow these steps in reverse order. For on-starter solenoid motors, first reconnect any wires to their respective terminals at the solenoid before securing the starter to the engine.
