Directions for Changing Bravada Brake Pads
Until GM stopped creation the Oldsmobile Bravada in 2004, it was engineered to exceed the safety standards place by the Insurance Academy for Highway Safety and the State Highway Traffic Safety Management. In array to preserve those standards, particularly regarding braking, Typical Motors recommends Correct usage and prolongation of the anti-lock braking operation. When the brake pads of the Bravada manifestation signs of wear, it is critical to exchange the brake pads as soon as feasible.
Safety and Set-up.
Lawns the Bravada in a point gone from passing traffic, with Sufficiently interval to commission on either side of the vehicle. Lay the transmission in "grassland" and engage the parking brake. Country tire blocks remain the rear tires to prevent the vehicle from rolling.
You Testament charge a tire iron, tire blocks, a lifting jack, jack stands, a Thirteen millimeter socket and ratchet and vise-grip pliers.
Changing the Brake pads.
Loosen the lug nuts with the socket on the tire iron.
Lift the Bravada using the lifting jack. Apartment jack stands below the frame of the vehicle. It is feasible to alter the brake pads with the vehicle supported by the jack single; on the contrary the jack does not feed a steady pattern from which to duty.
Remove the lug nuts and pull the wheels from the lug peanut bolts.
Set the brake caliper bolts on the away of the innermost side of the caliper.
Resetting the Caliper Piston and Finishing the Installation.
Press the brake pedal repeatedly to reset the caliper. When you opened the caliper with the vise-grip pliers, you expelled the brake fluid from the caliper.Provided the brakes are rusted, bid spraying the clips with chain lubricant or WD-40. Whether the lubricant is ineffective in loosening the obtain of the rust, pry the clips from the caliper using the blade of a Apartment lodgings screwdriver. Slide the brake pads from the caliper.
Clear the caliper piston with vise-grip pliers. The piston is the metal phone that sticks outside from one side of the caliper. The piston forces the pads against the rotor during braking. Squeeze the piston against the wall of the caliper until it is flush with the caliper wall. Slide the inexperienced pads onto the walls of the caliper.
Place the newly padded caliper around the rotor and replace the bolts. Use a Thirteen millimeter socket and ratchet to tighten the bolts. Place the wheel back onto the lug nut bolts and screw on the lug nuts by hand.
Lift the Bravada with the lifting jack to remove the jack stands, then lower the vehicle back to the road surface. Tighten the lug nuts with the tire iron.
Avail a Thirteen millimetre socket and ratchet to remove the two bolts. Pull the caliper from the rotor.The brake pads are constant to the caliper by metal clips that slide onto the caliper sides (or walls). Slide the pads from the caliper by ability.
Pressing the brake pedal will force fluid back into the brakes and move the caliper piston against the new brake pads.
The first few depressions of the brake pedal will come with little resistance. As the fluid returns to the brake caliper, setting it to its starting position for braking, the pedal will respond more normally.
