Brake rotor
The Two thousand three Mitsubishi Eclipse is equipped with all-wheel anti-lock disc brakes. Older models were fitted with disc brakes in the front with drum brakes in the rear. The addition of rear disc brakes means a higher level of braking performance, and has led to a substantial decrease in stopping distance while adding more control for the driver during braking. When the brake rotors are found to be warped or scored, remove the discs for resurfacing or replacement.
Instructions
1. Park the Eclipse on a flat surface, away from passing traffic. Lift the hood by pulling the hood release under the dashboard.
2. Remove the master cylinder cap. The master cylinder is on the driver's side or the engine compartment, capped by a white lid.
3. Loosen the lug nuts on the wheel that has the rotor that is to be removed. Use the tire iron included in the vehicle maintenance kit for the Mitsubishi. You can find the maintenance kit in the trunk of the Eclipse, stowed with the spare tire.
4. Lift the vehicle and support it with jack stands near the target wheel.
5. Remove the lug nuts by hand. Take the wheel from the wheel bolts and lay it flat on the ground with the rim facing skyward.
16. Tighten the lug nuts with the tire iron and return the tire iron and jack to the trunk.17.Check the master cylinder container and add brake fluid as necessary.
Pull the caliper from the caliper bracket and rest it onto the steering arm above the brake assembly. Do not allow the caliper to hang by the brake line.
8. Remove the two bolts on the backside of the caliper bracket. Use a Fifteen mm socket and ratchet to remove the two bolts and pull the bracket from the rotor.
9. Tap the center section of the rotor with a hammer to loosen the grip of the wheel bolts. Spray lubricant on the rotor to aid in extracting the disc from the Eclipse. Pull the rotor from the vehicle.
10. Take the new rotor from the packaging and spray the surface with brake cleaner. Wipe the excess cleaner from the rotor with a towel before placing it onto the wheel bolts.
11. Put the rotor on the wheel bolts with the center section (called the top hat section) facing away from the vehicle.
12. Return the caliper bracket to the rotor and replace the two bolts on the backside of the bracket with the Fifteen mm socket and ratchet.
13. Return the caliper onto the caliper bracket and screw in the two caliper bolts with the Thirteen mm socket and ratchet.
14. Place the wheel back over the brake assembly and screw on the lugs by hand.
15. Remove the jack stands and lower the Eclipse's tires to the ground with the jack.
6. Remove the caliper slide bolts with a Thirteen mm socket and ratchet. The two bolts are located on the side of the caliper facing away from you.7.
