Assign a Starter Solenoid in a One thousand nine hundred ninety four Ford Bronco
The starter solenoid on the One thousand nine hundred ninety four Ford Bronco is attached to the side of the starter Engine via tow bolts. To receive to the solenoid, you must remove the starter Engine from the transmission housing, as the solenoid is on the top of the starter housing. This makes it impossible to arrive the bolts and remove the solenoid while the starter remains on the Bronco. Happily, removing the starter requires the Emigration of equal two bolts.
Instructions
1. Fix the starter Engine under the engine on the Chauffeur's side of the Bronco. It attaches to the transmission housing. It is eight inches extensive and cylindrical in shape. You can examine the back of the starter solenoid on top of the starter Engine.
2. Remove the two bolts that secure both wires to the back of the starter solenoid, using a socket and ratchet. This disconnects the starter solenoid from the ignition. Part letter of where Everyone wire bolts.
3. Place the starter against the transmission housing, and secure the motor to the housing, using the original bolts.8. Connect both wires to the back of the starter solenoid with the socket and ratchet.
Remove the two bolts that secure the solenoid to the starter Engine, using a socket and ratchet.
6. Corner the dissimilar starter solenoid onto the starter motor. Thread the bolts that secure the solenoid to the housing with your fingers. Tighten them with the socket and ratchet.
7. Remove the bolts that secure the starter Engine to the transmission housing, using a socket and ratchet.4. Pull the starter off the transmission housing.5.
