Apply a total of three coats, keeping them thin so the paint doesn't run. Allow each coat to dry for Ten minutes. Open the paint gun, and add a small amount of reducer to the spray gun cup. Add one-fourth of the amount of reducer you measured and used for the original mixture.
When you employ this coat, you must blend it with the surrounding surface of your machine to prevent the repainting from fitting noticable.
Instructions
1. Compound the luminous coat colouring with the reducer according to the directions on the light coat can. Most clear coat paints require a ratio of one part reducer to four parts clear coat. Stir the mixture well, and pour it into a spray gun.
2. Spray over the entire area using left-to-right strokes---never up-and-down.
Blending clear coat whitewash results in a smooth, yet Stop.Halcyon coat serves as the top coat of nearly every emulsion labour institute on vehicles nowadays, providing a protective layer that keeps drying UV rays and other elements gone from the pattern colour coat. It too adds a layer of flash to the vehicle. You must practice a fresh coat of bright coat whenever you repaint an sphere.3. Spray the outer edges of the repaired area, outlining the border between the repaired area and the original surface with two thin coats. This mixture with the heavier amount of reducer thins the clear coat paint as you spray it and slightly "burns" the clear coat paint already on the car, giving the finished paint job a more even look.
