Alternate a damaged windscreen.
The windscreen is the front window of a vehicle, make-believe from a safety, laminated glass glued to the vehicle's frame. When a windscreen is cracked or otherwise damaged it is no longer considered guarded and has to be replaced. While installing a windscreen may be very circuitous at beginning glance, it is a chore that can be done away a adept windscreen function further. It is but, a challenging labour and requires consequent positive rules and vitality correct precise and careful.
Instructions
1. Remove the windscreen wipers and the rear opinion mirror. Allot them aside for next unless you are planning to change them, extremely.
2. Remove the decrepit rubber wrap approximately the edges. Capitalization a sharp assistance bait chopper to chop nailed down the urethane seal encompassing the edges, fracture it and remove it. This may receipts a while so be patient and precise. Cook not damage the senescent windscreen any very. When you shorten the top of the rubber seal, appliance a plastic baggage to pry the windscreen elsewhere or loosen it.
3. Remove the senescent windscreen using a glass suction object to lift the antiquated windshield. Lift the windshield slowly and carefully from the car completely. While lifting the glass, you can have someone help you tap the windshield from the inside of the car.
4. Clean the edges of the car window frame thoroughly using a sharp knife. Be careful not to receive any rubber inside the car. Use a small vacuum cleaner to remove all the dust and dirt particles. Then use a small thick brush and a multipurpose cleaner to remove the debris, dirt and rubber residue. Leave it to dry before proceeding with the windshield installation.
5. Clean the new windshield with a glass cleaner and a microfiber fabric. Wear thin latex gloves and make the auto glass as clean as possible.
6. Install the new rubber wrap or seal all around the new windshield, fitting it as you go with your hands. Before fitting it on the glass, use urethane primer to apply it to the edges. The primer will make the black rubber band stick firmly to the glass.
7. Lift the new windshield with the glass suction tool. If you can get some help, now is the time to use it: lifting a windshield with two glass suction tools at the same time makes the job a lot easier.9.
Apply urethane on the car front window frame using a caulk gun. Be precise and make sure that the urethane line is even and straight.8.
Place the new windshield on the windshield frame of your car. Center and position it to fit the frame and press it on the urethane to form a strong bond. Check all around to see if there are any gaps. If there are, use a caulking gun to apply more urethane or special waterproof sealant.
10. Install the plastic molding trim all around the windshield by pressing it into place, outside the auto glass. Check for a thin rubber tab between the auto glass and the car frame and fit the trim molding inside.
11. Re-install the rear view mirror and the windshield wipers. Clean any urethane from the auto glass surface with a brush and a cloth.
