On most Meeting place models, the pads are in the calipers.
You call for to convert your automobile's brake pads at 60,000 miles; they may require changing sooner depending on how burdensome you manipulate the brakes. On any Ford Locus untrue after 2000, the brake pads are held within the brake calipers themselves on the front wheels. Cover the replacement brake pads into the brake caliper or the mounting bracket as needed; in the former's situation, slide the outer pad and its clip into the caliper and subsume the inner pad's spring clip into the piston.7. Install the caliper back onto the bracket on the brake CD and then apply and tighten the mounting bolts with the wrench.8.
1. Uplift the machine's front aim with the floor jack and block it on axle stands. Remove both front wheels with the tire iron; exclusive donkeywork on one brake meeting at a future.
2. Pry off the retaining clip from the brake caliper using a Apartment lodgings belief screwdriver while holding the clip with pliers. Detach the brake hose's bracket from the strut meeting.
3. Remove the conductor pin bolts for the brake caliper and lift the caliper off the bracket. On most newer models, the bolts demand an Allen wrench and are covered with caps you must remove.
4. Remove the brake pads from the caliper mounting bracket or the caliper itself--if the pads are in the caliper, pull the inner pad and its spring clip away of the caliper piston and slide the outer pad outside of the caliper with its retaining clip.
5. Compress the caliper's piston back into its Muzzle slowly using a C-clamp. Whether elementary to prevent overflow, remove some brake fluid from the skillful cylinder reservoir in the engine compartment using a syringe or unused turkey baster.
Installation
6. Older models may gain them installed within the caliper's mounting bracket. Compose certain you annex the exactly brake pads for your specific imitation.
Instructions
Removal
Re-connect both wheels and lower the car off the axle stands after changing both sets of pads.
9. Fill the master cylinder reservoir with fresh brake fluid if needed.
10. Press the brake pedal multiple times until it feels firm, thus seating the pads.
