Disconnect the ground cable from the denial battery terminal by loosening the retaining bolt with a wrench and pulling the clamp off the terminal.3. Disconnect the acceptable cable from the battery. Over eternity, the starter may wear absent and must be replaced.
Instructions
Removing the Battery Box
1. Lift the front of your Neon with the floor jack, and buttress the vehivle on jack stands.
2.The Neon, a compact front-wheel-drive passenger vehivle, was manufactured by Chrysler from One thousand nine hundred ninety four to 2005. The Neon utilizes a little electrical Engine to begin the engine. A inadequate metal gear attached to the starter engages the flywheel (on handbook transmissions) or flex plate (automatic transmissions). When you turn the ignition vital, this gear rotates the crankshaft, which in turn starts the engine.
4. Pull away the bolt that secures the battery hold-down clamp to the battery tray, using a socket. Remove the hold-down clamp.
5. Remove the battery from the vehicle by lifting it straight up.
6. Employ a socket to pull gone the eight bolts that secure the battery box to the vehicle. Remove the battery box.
Removing the Fan Assembly
7. Adoption a Phillips screwdriver to loosen the two hose clamps that secure the upper radiator hose to the engine and radiator.
8. Remove the upper radiator hose by pulling it off the engine and transmission.
9. Cause a socket to pull away the four bolts along the top of the radiator that secure the fan meeting to the radiator.
10. Detach the electrical connectors from the fans. Appropriateness a flat-head screwdriver to pry the retaining clips gone from the connectors; then pull the electrical connectors off the fans.
11. Lift the fan meeting from the vehicle.
Removing the Starter
12. Remove the two wires that are connected to the starter. The anterior wire has an plastic connector that you can simply pull off. The other wire is retained by a aficionado; practice a socket to remove it.
13. Pull gone the two bolts that connect the starter to the engine, using a ratchet.
14. Remove the starter from the Neon.
Installing a New Starter
15. Lift the fresh starter into position.
16. Reinstall the two bolts that connect the starter to the engine block.
17.Reconnect the two wires to the starter solenoid.
Reinstalling the Fan Assembly
18. Blop the fan meeting into position against the radiator.
19. Reconnect the electrical connectors to the fans by sliding them onto the Trimmings.
20. Reinstall the four bolts along the top of the radiator that secure the fan meeting.
21. Reinstall the upper radiator hose by sliding the hose ends onto the Trimmings on the engine and radiator. Then apply a Phillips screwdriver to tighten the hose clamps.
Reinstalling the Battery
22. Blop the battery tray into position, and reinstall the eight bolts that secure it. Blop the battery into position in the tray.
23. Reinstall the battery hold-down clamp.
24. Reconnect the positive battery cable to the battery by sliding the clamp over the positive terminal and tightening the retaining bolt with a wrench. Reconnect the ground cable.
25. Lower the car.
