5. Drill four holes in your bucket that match the position of the holes on each side of the tooth bar. Attach the completed tooth bar to your bucket through the use of bolts, washers and nuts.
You can attach a tooth bar to a loader bucket on an earthmover in circuit to gap up earth, rip away tree stumps and proceeding rocks.
Instructions
1. Degree the bucket of your earthmover lengthwise from the inside line of Everyone side of the bucket, owing to your tooth bar rests within the bucket. Assemble decided to pay for a steel bar that has a broadness at least 4" deep on the other hand effect not shop for an excessively Broad lot of steel or you Testament bear to chop the diameter down to magnitude.
2. Shorten the length of the metal bar to match your measurement using either a hacksaw or reciprocating saying with a metal blade. For a faster chop, applicability a cutting torch or a grinder fitted with a metal cutting shove. Fabricate two holes on Everyone side of the bar three inches absent from Everyone borderline using a drill.
3. Decrease the teeth for the tooth bar from a late bar of steel with your desired broadness and length. You can attach the teeth by drilling an supplementary hole in the trunk of the tooth bar for each tooth you want to include. Weld the teeth to the trunk of the tooth bar using a MIG or oxyacetylene welder.
4. Attach the teeth to the truck of the tooth bar using bolts, washers and nuts. Hold a tooth above the trunk so that the bolt holes line up and stick a bolt through both the tooth and the trunk. Strip a washer over the bottom of the bolt and then tighten the bolt as much as possible using a socket wrench. Repeat the process until you have attached all teeth to the bar.
Tooth bars attach to the front of a tractor bucket.Instead of purchasing a tooth bar from a retail store, you can generate one inexpensively using welding Accoutrement and pieces of steel. Tooth bars consist of a metal bar attached by bolts to a loader bucket and a series of metal teeth. If you intend to keep the tooth bar on your power equipment permanently, you should weld the tooth bar to the bucket for a stronger hold.
